Shenzhen Top World Intelligent Technology Co., Ltd.
Service Hotline:0755-28261149
Banner
Home > news > Content

On the installation and adjustment of the weight detection machine conveyor

Conveyor belt is the key of weight detection machine transmission. It is a relatively important component. Without it, the entire equipment is completely in a recessed state, so users must have a correct understanding of the installation and adjustment of automatic weighing machine conveyor belts:

Installation of the weighing machine conveyor belt:

1. Rotate the adjusting nut to adjust the interval between the driven shaft and the driving shaft to a small distance;

2. Check the running direction of the selected scale belt, and set the belt into the tray according to the direction of the thick arrow in the instruction manual.

3. The conditioning nuts at both ends of the conditioning tray make the belt tension moderate. Place the belt in the center of the tray.

Adjustment of weight testing machine transmission belt:

1. Adjust the belt tension to a moderate level, put it on the machine, and investigate the running status of the leather;

2. If the belt is in the middle of the tray, it is in a normal state without any conditioning.

3. If the belt is skewed to the left, the following adjustments can be made:

1) The belt on the left can be “tightened” and needs to be adjusted gradually. Investigate while adjusting until the belt returns to the center. If you find that the conditioning nut is already tight, do not force it.

2) The belt on the right can be "unscrewed" and needs to be adjusted gradually. Investigate while adjusting until the belt returns to the center.

3) If it is too large, it is difficult to come back slowly after conditioning, you can loosen the right belt quickly.

4) If the belt is in friction with the side baffle, stop and check immediately.


Address:2F, Building B, 38 Guangda Road, Henggang Street, Longgang District, Shenzhen  电话:0755-28261149  MobilePhone:18665961659   E-mail:972250633@qq.com

Mobile